working principle(e.g.T8-1.2 meters)
1)In the car park use infrared sensors to control each infrared LED tubes,when no cars,all of the infrared LED tubes are dormant,and the power consumption is 6.0W/pcs,which can meet the requirement of security monitoring,and best good saving electricity(according to the previous experience the garage place can save electricity about 90% in 24 hours).
2)when the vehicle pass in and out,the corresponding infrared sensors will signal the infrared ray induction tube and awake the dormant LED tubes,the power is 12W,to replace 40W fluorescent lamp,owner parking is convenient,car or people in induction area,LED tubes keep lighted,when the car or people leave over 80 seconds,LED lamp to be automatic back into suspended animation and power is 6W.
3)each LED infrared tubes are integrated with a smart induction system,when people come,it will light, if not,light dark.
Product introduction:
The induction lamp is used the most advanced heat infrared detection sensor at present,the built-in temperature compensation and power circuit voltage control circuit.
The whole circuit use optimization design,and have high quality and precision for each of component material,stable induction,reliable work,is the first of the induction lamp with so high-quality,which get recognition from numerous consumer,and sells to markets at home and abroad.
Note:LED induction lamp have two types:
(1)full dark after bright,
(2)keep a little light,
Customers please pay attention to choose:
(1).In the first case,the light will delay lights 60 seconds after the people come and full dark after 3 minutes(Dormancy power consumption is around 0.3 watts),this lamp suit to the toilet, stair, corridor,wardrobe,ambry,etc.
(2).In the other case,the lamp is lighted after 60 seconds into the 20-50%(around 2-10 watts)low consumption electric working status,it suit to the underground parking garage,warehouse and the place of the light is dark,but need a little bit of brightness,most customers choose this one.
product specifications:
(1)Size:diameter of 0.26*0.30*(high-grade elliptic tubes)
(2)PC cover color:milky white;Transparent;Stripe(3 type can be first)
(3)House materials:high quality aluminum;
(4)Tube power:built-in constant voltage electronic human infrared sensing radar intelligent automatic LED induction controller drive power supply.
(5)PCB:Aluminum plate.
(6)Products weight:0.35kg(1.2m for the standard 0.35kg weight)
(7)Light source:3528 Epistar chip;
(8)LED quantity:12W:176pcs;15W:216pcs:
(9)low quantity of heat,high efficiency;
(10)The input voltage:85-240 volts,50-60hz;
(11)Work environment temperature:-20+50 degrees;Work environment humidity:65+20%RH
(12)Induction lights time for choice:a little light after 30 seconds, 60seconds, 80seconds, 180seconds (note:the time means lamp dark after people leave);
(13)Infrared sensors induction range:more than 3m(note:induction scope of the sensor is the vertical distance as the center of the lens on sensors.
Product features
Human body infrared sensing,using their spectra from human body,when someone get into LED lamp induction range:
(1)small lens is 1 cm in diameter,induction range 3 meters or so,error of 0.5 meters;
(2)the middle lens diameter is 1.8cm,sensing range is 4 meters,error of 0.5 meters;
(3)the big lens is 2.6cm,induction range 5 meters or so and error 0.5 meters,7-8meters is farthest,
special sensors to detect change of human infrared spectrum.Automatic output high electric frequency,when people don't leave induction range,high output will continue;when people leave,the switch will shut off load automatically delay.
note:
the first time after the power supply after the lights will be a little slow,induction time delay after a few seconds to light,or delay dozens of seconds before the lights,because sensors to charge,sensor for the first time a president of work time,this is normal phenomenon.
When the human body to leave its LED induction range,will automatically cut off the power supply,and thus realizes the automatic control.Automatic metering:may,according to the surrounding environment bright and dark to choose the induction lamp of stand by brightness(lamp can automatic induction or car all bright,people come after the car walk according to the set time back up to 10% or 20% and 30% WeiLiang lighting,can set freely 1%-100% of the brightness.Because underground garage to a little WeiLiang lighting,just won't appear spooky scary.More than 100% of the ChangLiang tubes province electricity more than 90%.
Automatic induction:Car come to light,one car go lamp:the optimal induced control design,can realize people come to light,automatic delay to put out,do not need to be to turn off the switch,energy saving is secured,no longer whether forget to turn off the lights for trouble.
.jpg)
.jpg)
.jpg)
.jpg)
